Application of Photosensitive CTP and Thermal CTP Technology (3)

VI. "Reducing Production Costs and Improving Efficiency"


project
Photosensitive technology
Thermal Technology
High quality brings high-end business and brings higher profits
Little help
The effect is remarkable
Printed product yield increased and consumption reduced
The effect is not significant
Overprinting is accurate and fast, the ink and ink balance is fast, and the consumption of overprinting paper and ink is reduced. Good consistency, improved yield
Reduced processes, reduced personnel, equipment and site costs
Safe light operation and punching cannot be avoided
The flush-free version has entered the practical stage, open-room operation,
Plate cost
Currently only a few manufacturers, domestic production has not yet been achieved
There are more than a dozen manufacturers, and there are already several domestic manufacturers.
Light source cost
Life is about 3000 hours and the light source price is low.
Life is also around 3,000 hours and the light source price is high. However, multi-channel independent laser tube grouping technologies such as screens greatly reduce the actual use cost of the light source.
Maintenance cost
Internal drum type, complex structure, high failure rate, sensitive core parts, high maintenance cost (see attached sheet)
External drum type stabilizing structure, low maintenance cost, low failure rate, low use cost
Environmental protection costs
Chemicals are unavoidable, especially the use of silver salt plates, the cost of environmental pollution control is high
No chemical use, low environmental costs

Key points:

1. The imaging principle determines the mode of implementation. The implementation mode determines the design idea. The design idea determines the cost of implementation.

2. The benefits of direct platemaking are comprehensive, combining the entire prepress and printing process. No matter what form of direct plate making technology is used, the use cost must be comprehensively calculated.

Seventh, summary:

1, photosensitive technology and thermal technology have their own strengths. Photosensitive technology is mainly used in the newspaper printing with high speed requirements and the short-run printing market with small format. The market for commercial printing and packaging printing, which requires high quality and accuracy, is mainly based on thermal technology.

2. The purpose of the introduction of direct plate making technology is to enhance the production management and quality control capabilities of enterprises, reduce production costs, shorten the printing cycle and so on. It is an important investment for the comprehensive development of enterprises. One-sided emphasis on the short-term plate material cost level, in the technical direction is easy to deviation or even extreme.

Any technology has its focus and adaptability, the key is to see if they adapt to our development ideas.

Source: bisenet

Sandblasted Anodized Aluminum Products are products firstly manufactured subject to drawings which produced by the R&D Department and then fabricated through sandblasting and anodizing treatment. The products after sandblasting and anodizing have such characteristics as anti-corrosion, abrasion resistance, heat resistance, weatherability, insulation and adsorption, etc. After sandblasting, the products looks more beautiful and elegant. Apart from the appearance, its characteritics are better than other material. Many household items, shell of electronics are made from such material.

Sandblasting Anodized Aluminum Products

Sandblasting Anodized Aluminum Products,Anodized Decorative Aluminum Plate,Sandblasting Anodized Aluminum Sheet,Decorative Sandblasting Aluminum Sheet

Jiangsu Boruixin Aluminum Technology Co.Ltd., , http://www.brx-aluminum.com